|
Click On Any Photo To See Large Version
Use Your Back Button To Return |
|
 |
View of left side of Locomotive 487, you can see the Mapping and the
spots that were ground into the Boiler to allow the Ultrasound
testing. |
|
 |
In this Picture you are looking at one of the Boiler seams or Joints
near the rear, all the Rivets are visible and you can see the ground
spots on the Boiler to allow the Ultra-sound testing. |
|
 |
In this picture, you are looking at a few of the removed Staybolts
and you can see the mapping that was drawn into the Boiler. |
|
 |
This a close-up and is similar to the above Picture. |
|
 |
You are looking to the rear of the Boiler and can see the Staybolt
Caps above the Firebox, 27 of these had to be removed to replace! |
|
 |
You are looking down at the Boiler and can see the Main Fountain
that supplies the steam to run the Injectors and Air Pump and other
appliances in the Cab. This Fountain sits directly ahead of the Cab! |
|
 |
Same as the previous picture, you can see the Throttle Supports and
the water glass attachments. |
|
 |
Again, you are looking at the Boiler and a few of the Staybolt Caps. |
|
 |
Ronnie Lopez is using a torch to burn off old Grease on the Bolster
of one of 488's Tender Trucks. |
|
 |
Same as the previous Picture. Tender Bolster of Locomotive 488's
tender. |
|
 |
Close-up of 487's rear Back-head of Boiler. This shows some of the
Ultra-sound numbers and figures. |
|
 |
This is a closer shot of the previous picture... you can see the
Fireman Water Glass attachment to the right. |
|
 |
Early morning in the Antonito, Jan 22nd at about 7:30 A.M.. |
|
 |
The Antonito Depot under a Fresh Snow. |
|
 |
Another early morning Photo of Antonito. |
|
 |
Marvin Casias using a Air-Arc to cut away old worn metal before
replacing and re-welding on the bolster of 488's Tender. |
|
 |
Early Morning frost on the tree's in Antonito. |
|
 |
A interior picture of 487's smokebox after needle-scaling to remove
carbon build up on the surface. |
|
 |
487's needle-scaled Smokebox Door. |
|
 |
Julio working on and welding on 484's front Flue-sheet. |
|
 |
Cutting and measuring the small flues in Chama. |
|
 |
Preparing to bore a Locomotive's Cylinder. |
|
 |
Installing Small flues in a locomotive in Chama. |
